JC Racing Aluminum Drag Racing Tie Rods - Set of 2 JCEDS03

These drag tie rods are machined from 6061-T6 billet aluminum. They also offer a custom look and a weight savings over the stock tie rods.

INSTRUCTION:

• They do not have to be removed to be adjusted as the heim joints are threaded opposite of each other.
• Simply loosen the jam nuts
• Twist the tie rod body to the left it gets longer or twist it to the right and it gets shorter,
• Then retighten the jam nuts. This allows you to adjust the toe in and out of your front end.

You will need to measure your tie rods so we can make these the same length.

Measurements are usually taken from the center of the bolts hole to the center of the other bolt hole.

You may also have to shim the tie rods away from the spindles or the steering stem some using flat washers in some cases.

Heim joints used on these tie rods are 3/8".

Included:

- 2 Aluminum Tie rods

- 4 Aluminum Heim Joints/Nuts

Note: These tie rods come as a complete set of 2.

WILL FIT:

ATV's, Honda - 250R , TRX450R , TRX700XX , TRX400EX , Yamaha - YFZ450 , Banshee , Raptor 660 and 700 , Blaster , Warrior , Suzuki - LTR450R , LT250R , LT500 , Kawasaki - KFX450R , Also fits custom chassis.