1992-1993 Acura Integra (non GS-R) Innovative Steel Replacement Mount Kit (B18A1/Manual/Hydro/Cable 2 Hydro) - 60A RED

Replacement/Conversion Mount Kit for the 1992-1993 Acura Integra (DA9)
Designed to fit the Acura Integra DA9 chassis with B-Series(B18A1) motors with manual hydraulic transmission.

IMPORTANT:
This kit was meant for non GSR vehicles. For the GSR kit please see:
- 90-91 INTEGRA / 92-93 GSR REPLACEMENT / CONVERSION MOUNT KIT FOR B-SERIES (MANUAL / HYDRO) - 49350

This kit also works when converting cable to hydraulic transmission.

Kit includes our 41000 actuator, to purchase this kit without the actuator check the box next to ""No Actuator"" under Misc. Options.Actuator pivots smoothly using state of the art spherical bearings.
The actuator is mounted in the same fashion as the factory models and works in the same plane as the clutch release fork.
There is no binding in the clutch release fork and therefore no premature clutch wear caused by the actuator.

It is strongly recommended that all installs be done by a mechanic or automotive specialist.
Mounts CAN NOT be returned or swapped out after they have been bolted down (revealing bolt impressions).

PLEASE MAKE SURE THIS KIT FITS YOUR VEHICLE BEFORE BOLTING THEM IN PLACE.

Innovative Engine Mounts are built for performance driving.
Although Innovative's bushings are made to absorb engine vibration, you may still notice slight vibration depending on your engine's series and HP.
Innovative Mounts removes the dampening oil containers harbored by OEM/Stock mounts.
By switching to stiffer mounts without the fluid reduces wheel hop and increases driving response.

- Unique no-tear vibration minimizing bushings
- CAD/CAM Designed
- Stress Analyzed
- Lifetime Warranty

This kit includes 3 mounts; Front, Rear, Passenger and a cable to hydro actuator.

Weight: 15lbs

Vehicle Fitment Notes
Cable-to-Hydro conversion (actuator included)

NOTE: Most items are special ordered and may take up to 2-3 weeks